PatternPly® Acrylic Solid White on Black
1/8” black acrylic with solid white on both sides
~12 x 19.2”
Set material to Medium Clear Acrylic
Engrave: default but change focus to 0.325 in
These settings are a starting point. Always test a small area of the sheet before starting a project in case further fine tuning is necessary for your laser.
Suggested cut settings**: GF Basic: Set material to medium clear acrylic. Cut: 168/full Engrave: full power/full speed but defocus to 0.325in GF Pro: Set material to medium clear acrylic Cut: 168/100 Engrave: full power/full speed but defocus to 0.325in If your material comes masked on one side, it is suggested that you cut with the masking down. **Every individual laser is a little different. These are merely starting points. Always do a small test cut, as you may need to speed up or slow down slightly for your laser's ideal settings. If you are experiencing issues with flashback, you can elevate off of the honeycomb tray with small scraps in the corners and around the edges under the material. If you do this, add the thickness of the offset material to your defocus.
Not sure which PatternPly® option you need? Check out our PatternPly® Guide"